Difference between revisions of "BFM tactics"

From UOAF Codex
Jump to navigation Jump to search
Line 17: Line 17:
 
* [http://www.krauselabs.net/dump/FighterCombatTactics.pdf Shaw's Fighter Combat Tactics and Maneuvering]
 
* [http://www.krauselabs.net/dump/FighterCombatTactics.pdf Shaw's Fighter Combat Tactics and Maneuvering]
 
*[http://www.simhq.com/_air/air_097a.html How to be a Good Stick]
 
*[http://www.simhq.com/_air/air_097a.html How to be a Good Stick]
 +
 +
=Geometry of Air Combat=
 +
==Positional Geometry==
 +
Angle-off, range and aspect angle are terms used in BFM discussions to describe the relative advantage or disadvantage that one aircraft has in realtion to another
 +
 +
===Angle-off===
 +
Angle-off is the difference measured in degrees, between your heading and the bandit's. This angle provides information about the relative fuselage alignment between the pilot's jet and the bandit's.<br />
 +
For example, if the angle-off between you and a bandit were 0°, you would be on a parallel heading with the bandit and the two fuselages would be aligned.
 +
[[File:BMS BFM-angle-off.jpg||centre|350px|]]
 +
 +
===Aspect Angle===
 +
Aspect angle is the number of degrees measured from the tail of the target to your aircraft. Aspect angle is important because it indicates how far away your aircraft is from the target's 6 o'clock position.<br />
 +
Aspect angle has nothing to do with your heading. Note that the aspect angle stays the same regardless of wich way your aircraft is heading (see figure)<br />
 +
Along with a measure in degrees from the target's tail aspect angles are also described either right or left aspect.<br />
 +
Aspect angle is important because, if you know the aspect angle and range to the target you then know his lateral displacement or turning room from the target and lateral displacement is very important in BFM.
 +
[[File:BMS BFM-aspect angle.jpg||centre|350px|]]
 +
 +
==Attack Geometry==
 +
Attack geometry describes the path that the offensive fighter takes as he converges on the bandit. When you start an attack on the bandit, there are three distinct path or pursuit courses you can follow. These pursuit courses are lag pursuit, pure pursuit and lead pursuit.<br />
 +
If you are pointing your aircraft behind the bandit, you are in lag pursuit. if you are pointing directly at the bandit, you are in pure pursuit. If you are pointing in front of the bandit, you are in lead pursuit.
 +
[[File:BMS BFM-pursuit-courses.jpg||centre|350px|]]
 +
 +
===Lag Pursuit===
 +
Lag pursuit is used primarly on the approach to the bandit. Lag is also used any time an attacking fighter maneuvers out of plane (not in the same plane of motion as the fighter under attack)<br />
 +
You must have the ability to out-turn the bandit in order to fly lag pursuit for any length of time. The reason ?<br />
 +
In order to shoot a missile or the gun at the ennemy, you must pull your nose out of lag. If the bandit can turn at a higher rate, he can keep your nose stuck in lag and keep you from shooting him.
 +
 +
===Pure Pursuit===
 +
Pure pursuit is used to shoot missiles at the enemy. Flying a pure pursuit course all the way into the bandit will lead to an overshoot.<br />
 +
For this reason, you should only point at the bandit when you are going to shoot.
 +
[[File:BMS BFM-pure-pursuit.jpg||centre|350px|]]
 +
 +
 +
===Lead Pursuit===
 +
Lead pursuit is used to close on the bandit and is also used for gun shots. Flying a lead pursuit course if the fatest way to get to the bandit because you cut him off in the sky. The problem with establishing a lead pursuit course too early is that you will overshoot the bandit when you get in close unless you have a significant turn rate advantage.<br />
 +
If you're fighting a similar aircraft, such as the Mig29, you will not normally be able to stay in lead and will be forced into an overshoot.<br />
 +
It is important however to establish lead pursuit at the proper time in the fight because it is the only way that you can get into the gun envelope.
 +
 +
=Offensive BFM=
 +
==Turn radius and Turn rate==
 +
==Corner Velocity==
 +
 +
=Defensive BFM=
 +
==Bandit outside your turn circle==
 +
==Bandit inside your turn circle==
 +
==overshoots==
 +
==Guns Defense==
  
 
=Energy=
 
=Energy=

Revision as of 13:55, 14 April 2017

Scissors.jpg

Learning objectives

  1. Understand the concept of energy
  2. Understand the concept of lift vector
  3. Understand the concept of the corner speed (turn radius vs turn rate)
  4. Know the different pursuit curves. (Lead, lag and pure pursuit)
  5. know the high and low yoyo maneuvers
  6. know the difference between one circle and two circles turns and when to employ them
  7. know the flat and rolling scissors
  8. understand the concept of flying the elbow
  9. understand the concept of the egg (god's G)
  10. know how to use the dogfight mode, the HMCS and the radar modes linked to them
  11. know the brevity words usualy used in dogfight

Learning files

Geometry of Air Combat

Positional Geometry

Angle-off, range and aspect angle are terms used in BFM discussions to describe the relative advantage or disadvantage that one aircraft has in realtion to another

Angle-off

Angle-off is the difference measured in degrees, between your heading and the bandit's. This angle provides information about the relative fuselage alignment between the pilot's jet and the bandit's.
For example, if the angle-off between you and a bandit were 0°, you would be on a parallel heading with the bandit and the two fuselages would be aligned.

BMS BFM-angle-off.jpg

Aspect Angle

Aspect angle is the number of degrees measured from the tail of the target to your aircraft. Aspect angle is important because it indicates how far away your aircraft is from the target's 6 o'clock position.
Aspect angle has nothing to do with your heading. Note that the aspect angle stays the same regardless of wich way your aircraft is heading (see figure)
Along with a measure in degrees from the target's tail aspect angles are also described either right or left aspect.
Aspect angle is important because, if you know the aspect angle and range to the target you then know his lateral displacement or turning room from the target and lateral displacement is very important in BFM.

BMS BFM-aspect angle.jpg

Attack Geometry

Attack geometry describes the path that the offensive fighter takes as he converges on the bandit. When you start an attack on the bandit, there are three distinct path or pursuit courses you can follow. These pursuit courses are lag pursuit, pure pursuit and lead pursuit.
If you are pointing your aircraft behind the bandit, you are in lag pursuit. if you are pointing directly at the bandit, you are in pure pursuit. If you are pointing in front of the bandit, you are in lead pursuit.

BMS BFM-pursuit-courses.jpg

Lag Pursuit

Lag pursuit is used primarly on the approach to the bandit. Lag is also used any time an attacking fighter maneuvers out of plane (not in the same plane of motion as the fighter under attack)
You must have the ability to out-turn the bandit in order to fly lag pursuit for any length of time. The reason ?
In order to shoot a missile or the gun at the ennemy, you must pull your nose out of lag. If the bandit can turn at a higher rate, he can keep your nose stuck in lag and keep you from shooting him.

Pure Pursuit

Pure pursuit is used to shoot missiles at the enemy. Flying a pure pursuit course all the way into the bandit will lead to an overshoot.
For this reason, you should only point at the bandit when you are going to shoot.

BMS BFM-pure-pursuit.jpg


Lead Pursuit

Lead pursuit is used to close on the bandit and is also used for gun shots. Flying a lead pursuit course if the fatest way to get to the bandit because you cut him off in the sky. The problem with establishing a lead pursuit course too early is that you will overshoot the bandit when you get in close unless you have a significant turn rate advantage.
If you're fighting a similar aircraft, such as the Mig29, you will not normally be able to stay in lead and will be forced into an overshoot.
It is important however to establish lead pursuit at the proper time in the fight because it is the only way that you can get into the gun envelope.

Offensive BFM

Turn radius and Turn rate

Corner Velocity

Defensive BFM

Bandit outside your turn circle

Bandit inside your turn circle

overshoots

Guns Defense

Energy

Em.jpg
  • 0.55 Mach is around 366 knots
  • Don’t pull back hard on the stick and unnecessarily bleed off energy


Video Examples

{{#invoke:Navbox|navbox}}